hi all,

currently loosely looking at MPS' either a mk1 3 or more likely a 6.

current ride is a blobeye scooby wagon stage 2 tuned to 340hp / 320 ft lbs




am interested in a 6 as a more 'sedate' Q car, the scoob gets lots of attention (both good and bad )

cheers,

Think you will enjoy the 6, be aware of the high tax bracket as it might or might not affect your decision

_________________
S.W.A.L.R.

** Warning this post may contain sarcasm and/or banter.......it's your decision to get upset about it **

Pre-march (23rd?) 2006 55/06 reg to avoid higher tax.

_________________
ZZB March 2013 :(

Hello & Good luck with the search!

Hello there, good look with the search.

You'll have to spend a fair few £ to get to your scoobies 340 standard though.

_________________
100% Meth / Fully forged / ACT 6 Puc & lightweight flywheel / monlar rods / wiseco pistons / arp studs / Versatune / corksport FMIC / Garrett GTX3076 / Brock Injector seals / Autotechs / Dreadnought & Juggernaut / GT RARB / Speedline front lower struts / Speedline lateral struts / corksport front braces / corksport rear upper braces / CS side braces /H&R springs / Bilstein B8's / CS BBK / Rear EBC Yellowstuff / JBR 5mm spacers / JBR OCC / Forge V2 / AWR 80a REM / 3" DP / Jetex / 3.25" Sure intake / Sure BSD / SURE TIG / Butterfly delete / EGR blockoff / Hel brake lines / Xcarlink / kendo SSP & Bushes / Step colder NGK 0.6mm gap / Fog and Driving light HID's / MKii alloys
Build thread http://tinyurl.com/otzp6qw
Helpful threads http://tinyurl.com/kjykgbd
http://www.ThroughTheLensMedia.co.uk
AVOID TOTAL MPS http://www.mpsowners.co.uk/viewtopic.php?f=64&t=20073

i would opt for a 3 mk1, no grandad labelling going on then

but in all fairness both are great cars, no experience in a 6 but from what i've read on here

_________________
Mazda 3 MPS Crystal White Pearl Mk2 - Stock

Hello & good luck with your search

_________________
Eco warrior lol

thanks guys - is there no-one in the south with an MPS?!?!? was hoping someone could take me out for a ride and let me see one up close

my ex had a mk1 3 sport which was a great car, but i'm dubious about going back to FWD - hence the preference ATM for a 6.

yeah, scoob has cost me a reasonable amount - coilovers, bigger turbo, injectors, FMIC, air filter cone, harvey up pipe, harvey 3 port boost solenoid, fuel pump, BOV, alloy race rad, not forgetting remap.

its pretty nippy ,

guess i just feel like a change, scoob gets good and bad attention as stated. it gets boring with every chav trying to race you or trying to provoke a show of how fast/slow they think your car will be.

so this is why i quite fancy a 6 - not many about and even fewer know what they are.

Where abouts South? A lot do seem to be up North though - had to travel to get mine

_________________
Black MK1 3 MPS Aero - AP Tuned - Now SOLD - but not forgotton
Showroom Thread

Hello and so is the scooby up for sale then ?

_________________
Titanium 6MPS, Cpe XL TIP/CAI, AEM Filter, PTP HPFPI, NGK Plugs, Forge recirc valve, C&C Custom 3'' System, Cpe RMM, J-Speed SSP, Eibach pro springs, Gloss Black RX-8 Wheels, Falken rubber, M-Tech D&G disc with yellowstuff pads all round, HEL BBL, DOT5.1 Fluid, Red Calipers, Black out badges and Tints.
To fit = Hd lip, Sure Anchors
289bhp & 295ftlb

Future Mods = Corksport TMIC

to the forum.

There's a few down south , I'm sure you can get a ride of someone

_________________
Useful threads and FAQ's (members only)

scoob only up for sale if i can find the right MPS

Hi and to the forum. I'm in the Southeast area - where you at?

_________________
2010 MPS3 Mk2 Forged / Sleeved Engine, CS Cams and Crower Valve Springs, BNR S4 Turbo, HTP 3.5" Intake, HPFP Internals, 2050psi Fuel Rail Relief Valve, JMF Intake Manifold, DNP Exhaust Manifold, Dual OCC Setup, Cobb Turbo Back Exhaust, Airtec FMIC, Port Methanol Injection ..... Tuning in progress with a goal of 480-500bhp :-)

What he means is, can I try your scooby out if you try my 6

_________________
100% Meth / Fully forged / ACT 6 Puc & lightweight flywheel / monlar rods / wiseco pistons / arp studs / Versatune / corksport FMIC / Garrett GTX3076 / Brock Injector seals / Autotechs / Dreadnought & Juggernaut / GT RARB / Speedline front lower struts / Speedline lateral struts / corksport front braces / corksport rear upper braces / CS side braces /H&R springs / Bilstein B8's / CS BBK / Rear EBC Yellowstuff / JBR 5mm spacers / JBR OCC / Forge V2 / AWR 80a REM / 3" DP / Jetex / 3.25" Sure intake / Sure BSD / SURE TIG / Butterfly delete / EGR blockoff / Hel brake lines / Xcarlink / kendo SSP & Bushes / Step colder NGK 0.6mm gap / Fog and Driving light HID's / MKii alloys
Build thread http://tinyurl.com/otzp6qw
Helpful threads http://tinyurl.com/kjykgbd
http://www.ThroughTheLensMedia.co.uk
AVOID TOTAL MPS http://www.mpsowners.co.uk/viewtopic.php?f=64&t=20073

ah, sorry, slow on the uptake there!

yeah, fairs fair after all, a go in mine for a go in yours

DJJUT - i'm J3 of M25 so only just the kent side of the river whereabouts in essex are you?